The iQpump^® integrated pump specific software allows the operator to quickly set up specific control values for a wide rante of applications. The controller then automatically adjusts pump operation as the system variables change while still maintaining optimum pump performance and protection.

• Programmable Set Point & Scaling... 12 different plain text engineering units are avilable, including PSI and GPM
• Control Pressure, Start Level & Start Time... flexibility to start the pump at different feedback levels or use the integrated timer to eliminate cycling.
• Sleep Mode Minimum Flow Protection... protects and shuts down the pump at low speeds or in low flow conditions.
• No Flow Detection... separate from Sleep Mode, this detects changes in motor RPM relative to sudden changes in pressure or flow; protecting against broken pipe, excessive well drawdown or run-dry conditions.
• Pre-Charge Control... this programmable feature eliminates water hammer and extends system life by gradually filling a pipe line before normal full pressure and flow operation. Motor speed can be controlled with a system timer, level or pressure control device to indicate when normal operation may begin.
• Thrust Bearing Control... protects the bearings of submersible motors by ensuring start up speeds and times meet manufacturer's recommendations.
• Automatic System Restart... programmable timers allow the iQpump^® to automaticalloy restart the system in Auto Mode for faults relating to brown out's, no power, power spikes, and dry well.
• Friction Loss Compensation... automatically adjusts to overcome increased friction loss due to increased flows.
• Low & High Pressure Feedback Detection... iQpump^® continously monitors the system feedback device to provide a warning alarm or fault based on programmed level.
• Multi-Pump Operations... iQpump^® systems can be set up to automatically control two or more pumps to meet specific demands.
• Multiplex Automatic Stabilization... iQpump^® automatically balances multi-pump systems to stabilize performance and reduce cycling.

• Pump Fault and Alarms... iQpump^® provides a comprehensive set of pump related alarms and faults. Faults are displayed on the keypad in clear text to eliminate confusion.
  • Over Cycling
  • No Flow
  • Loss of Prime
  • Transducer Loss
  • Over Torque
  • Low & High Pressure Feedback detection
  • Pump Over Cycling
  • Dry Well
• Motor Protection... iQpump^® protects the motor by monitoring
  • Output Phase Loss
  • Ground Fault
  • Motor Overload
  • Motor Over Tmperature
  • Broken Shaft
• iQpump^® Drive Protection...
  • Over Voltage
  • Input Phase Loss
  • Under Voltage
  • Phase Imbalance
  • Short Circuit
• Transducer Loss Protection... iQpump^® monitors the feedback device voltage or current levels to determine if the transducer has failed.