FAQ# MTN-7N8UKZ Published: 10/18/2010

Question:What are the remedies when an I/O configuration error is present in MotionWorks IEC?
This error is caused when the configured IEC drivers cannot find the I/O devices when the IEC application is started. The IEC application's I/O drivers listed in the IO_Configuration section of the Project Tree must match the drivers that were configured and saved in the Hardware Configuration. This error is possible if the Hardware Configuration was updated and saved, but the controller was not rebooted to activate the new drivers.

To fix, Launch Hardware Configuration, go Online and Save the new configuration to the project folder and to the controller. Cycle power to allow the new configuration to take effect when the controller boots up.

Product Information:

Product Group:Motion
Product:MotionWorks IEC, MP2000iec Series, MP2300Siec, MP2310iec, MP2600iec
Category:Alarm; Instructions; Troubleshooting
Part/Model#: MotionWorks IEC, MP2300Siec

Other Information:

Link to related files:

Please read and understand the product instruction manual before installing, servicing or operating Yaskawa products. FAQ content and illustrations are provided as technical advice to augment the information in manual, not superceed it. It is not possible to give detailed instructions for all types of installation or support activities. The information described in the FAQs are subject to change without notice to improve the product or FAQ. Yaskawa assumes no responsibility for errors or omissions or damages resulting from the use of the information contained in any FAQ. All warnings, cautions and product instruction for product use must be followed. Installation, operation and maintenance should be carried out by qualified personnel. Failure to observe these and other precautions highlighted in the product manuals will expose the user to high voltages resulting in, serious injury or death. Qualified personnel are defined as individuals who are familiar with the installation, starting, operation and maintenance of Yaskawa products of the type described and have proper qualifications to perform the work.