Support

Frequently Asked Questions

Didn't find what you were looking for? Try
  Question Posted Date

Where can I find UL certification documents for Yaskawa MPiec Controller products?

06/12/2014

Where can I find the supporting documents for UL approval of the MP2000 controllers?

02/04/2011

Where can I find frequently asked questions for MV1000?

03/31/2015

Where can Error Code Descriptions be found for SigmaLogic?

10/20/2014

Where are the help files located for SigmaLogic, LogicWorks and Add-on Instructions (AOI)?

10/09/2014

When will single phase input capacities be available for P1000 and what kind of derating is expected?

06/29/2012

When will single phase input capacities be available for A1000 and what kind of derating is expected?

01/03/2011

When will a heatsink through the back solution be available, and what enclosure rating will it be capable of?

11/29/2011

When using the analog output function on a GPD506/P5, how is the output scaled when output current is selected?

06/12/2014

When using SMC-2000 analog input, where is the ground (common) signal connected?

05/22/2001

When using SigmaWin software, what are the units when graphing torque?

07/13/2004

When using MotionWorks IEC ver3.3.0, how can the error message “Library does not exist” be avoided when saving the Hardware Configuration?

01/27/2017

When using MotionWorks+, is there a way to tell which version of a project is currently in the RAM memory of the MP940 and the last date it was revised?

07/13/2004

When using DriveWizard HVAC on a Z1000 Bypass do I connect to the Z1000 Drive or the Electronic Bypass Contol PCB?

05/23/2013

When using an MP920's SVA Servo interface and an absolute encoder on a Sigma II Servopack (SGDH), how is the absolute data requested and confirmed complete in the application program?

09/21/2004

When using an absolute encoder, is it possible to set the absolute zero position through the Fieldbus Network?

01/09/2002

When using 2 option cards, I am receiving an OPE06 fault and am not seeing all the F1 parameters. I am using CN5-B for my encoder feedback card.

10/09/2012

When the personal computer (PC) serial port connection is disconnected from the controller, why does the SMC-2000/3010/4000 controller become unresponsive?

07/13/2004

When the E7 drive trips out on a fault it must be manually reset. Can the E7 be set to restart automatically after a fault?

06/08/2007

When setting parameter Pn300 (Speed Reference Input Gain) what rated speed should be used for Linear Motor applications?

02/18/2009

SAFETY PRECAUTIONS AND INSTRUCTIONS FOR USE OF FAQ INFORMATION!

Please read and understand the product instruction manual before installing, servicing or operating Yaskawa products. FAQ content and illustrations are provided as technical advice to augment the information in manual, not supersede it. It is not possible to give detailed instructions for all types of installation or support activities. The information described in the FAQs are subject to change without notice to improve the product or FAQ. Yaskawa assumes no responsibility for errors or omissions or damages resulting from the use of the information contained in any FAQ. All warnings, cautions and product instruction for product use must be followed. Installation, operation and maintenance should be carried out by qualified personnel. Failure to observe these and other precautions highlighted in the product manuals will expose the user to high voltages resulting in, serious injury or death. Qualified personnel are defined as individuals who are familiar with the installation, starting, operation and maintenance of Yaskawa products of the type described and have proper qualifications to perform the work.