Support

Frequently Asked Questions

Didn't find what you were looking for? Try
  Question Posted Date

Can I connect my smartphone or tablet to the GA500?

09/30/2019

Can CAM profiles/recipes reside in the SMC motion controller and how many separate points of data are possible?

01/21/2005

Can cam data be imported into SigmaSelect when using Blend Mode in MotionWorks IEC Cam Editor?

12/15/2014

Can a smooth shaft Yaskawa motor be replaced with one that has keyway shaft?

01/04/2002

Can a single HMI be used to communicate to multiple controllers?

05/22/2001

Can a SGD7S Analog SERVOPACK in speed control with an analog voltage reference use a sequence input to change the running Servomotor direction?

02/15/2017

Can a servomotor be energized while it is moving?

07/31/2001

Can a remote Hand/Off/Auto switch be connected to the E7B product?

06/08/2007

Can an SGMJV-08A motor be driven by SGDV-2R8F 100V drive?

03/03/2015

Can an MPiec Series Controller be programmed to measure the length a product passing on a conveyor?

03/10/2014

Can an external 24V power supply be used with the GPD515/G5 Logic Inputs?

07/13/2004

Can an EtherCAT Master monitor the external incremental encoder position of an SGD7 EtherCAT SERVOPACK with a Fully-closed Module (SGDV-OFA01A)?

08/12/2019

Can a negative speed reference be used to command the drive to reverse direction when using the Profibus option?

01/10/2003

Can a motor with less capacity than the capacity of the V7 Drive be used?

06/20/2013

Can a MCCB rated higher than the recommended rating, be installed ahead of a drive to supply the 3 phase power?

06/12/2014

Can a J7 Drove fault be indicated by a drive relay output signal?

06/20/2013

Can a Dynamic Braking resistor be installed on a J7 Drive?

10/11/2004

CALL SI-F/G ComCall -- Fault Code Description

06/08/2007

CALL -- Fault Code Description

06/08/2007

CAL -- Fault Code Description

06/08/2007

SAFETY PRECAUTIONS AND INSTRUCTIONS FOR USE OF FAQ INFORMATION!

Please read and understand the product instruction manual before installing, servicing or operating Yaskawa products. FAQ content and illustrations are provided as technical advice to augment the information in manual, not supersede it. It is not possible to give detailed instructions for all types of installation or support activities. The information described in the FAQs are subject to change without notice to improve the product or FAQ. Yaskawa assumes no responsibility for errors or omissions or damages resulting from the use of the information contained in any FAQ. All warnings, cautions and product instruction for product use must be followed. Installation, operation and maintenance should be carried out by qualified personnel. Failure to observe these and other precautions highlighted in the product manuals will expose the user to high voltages resulting in, serious injury or death. Qualified personnel are defined as individuals who are familiar with the installation, starting, operation and maintenance of Yaskawa products of the type described and have proper qualifications to perform the work.