Yaskawa Compass

Yes, I, J, K for circle mode is supported.

It depends on the application, and also on the group mechanism configured in the MotionWorks IEC Pro Hardware Configuration. For most systems described below, axes can be operated by more than one motor in a shared load (prime axis) configuration, which is supported and transparent to a Compass solution.

G-Codes X Y Z A B C and E are linked to world space Cartesian and Rotational axes, E is linked to the active extruder when configured as a 3D Printer. The use of a machine requiring A and B rotational motion requires an MP3000iec series controller ending in part number –ER. -ER release is expected Summer 2020 with UL certification

For 3D printing, typically a three-axis gantry plus up to three extruders can be configured.

For Milling, typically a three-axis gantry plus auxiliary axes for tangent and up to three spindles can be configured.

Any group configured in the MotionWorks IEC Pro Hardware Configuration can be controlled by Compass and G-Code.
Because the Compass solution is highly customizable, any number of additional (typically unsynchronized) axes can be added and customized for operations outside of the traditional G-Code use case, only limited by the number of axes the MP3000iec series controller can support. MP3000iec series controller can support up to 62 axes.

Compass was designed to be screen resolution-independent, but ideally, the resolution is 1920x1080.

Compass will run on virtually any resolution, the screen panels scale based on the window size, but sometimes there maybe font or other display issues during extreme scaling conditions such as 1024 x 720. Compass is also designed to support portrait mode.

• 1.6 GHz CPU, 4 GB memory, mainly a requirement of the operating system
• 1280x1024 display or higher resolution mounted horizontal or vertical
• Any modern hard drive size is sufficient. Flash drive / non-moving mechanism
  recommended
• 100 BaseT Ethernet connection

More information can be found in Doc# AN.MWIEC.06.

It’s unlimited because the file is streamed from the PC to the controller as the part is processed. The Toolbox side of the Compass solution on the MP3000iec series controller was designed to hold up to 500 instructions in a circular buffer.

Yes, a PC with Windows 10 OS is required. There also needs to be a network connection between the MPiec controller and the PC.

User Dialogs can be used in many different scenarios for OEMs to create custom responses for different application states.  Here is one example. If there is a sensor used as a digital input to the controller to indicate when the filament is running low for a 3D Printer, a User Dialog would prompt when the input triggers. There could then be two options to proceed from the User Dialog using the checkmark (OK) or X (cancel) button on the dialog. If the checkmark (OK) button is clicked, it will put the machine in a paused state. Conversely, if the X (cancel) button is pressed instead, it allows the G Code to keep executing if a G Code file is currently being run in Auto Mode. The above is just one example of the many ways the User Dialogs can be utilized.

To change the units used in the Position Display navigate to the Machine Configuration page, drop down cartesian axes, check the box for Override and choose your preferred units to be used in the Position Display.

To change the units of your commands in a G Code file you can either execute a G20 (set commands to be in inches) or a G21 (set commands to be in mm). It is common that a G Code file will specify G20 or G21 at the beginning of the file.

One key benefit of Compass is the OEM branding. Typically, OEMs who already own their custom front end may find their front end outdated and difficult to support. Yaskawa Compass provides OEMs with a complete and flexible solution while giving them the ability to maintain their own unique branding.